Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC's adjustable front upper control arms for Tacomas, PreRunners and 4-Runners. Featuring our long life maintainable ball joint and SpecRide bushings, this arm is designed to correct alignment angles while maintaining factory ride quality. SPC's integrated tubular and cast steel design provides the strength and durability needed for the most demanding environments. These remove and replace arms are available in pairs for lifted and off-road applications. Get more droop travel: SPC's arm has improved clearance to get around the spring bucket when the arm droops, eliminating arm to frame contact on lifted trucks. The maintainable ball joint has an oversized ball and allows more than 80deg of articulation to ensure it never binds. SpecRide bushings have free pivot to eliminate any chance of bushing failure seen in many high travel suspensions. Get your drivability and tracking back:When you lift your truck you affect caster and camber. SPC's arm have +1deg of caster built into them. Using its patented ball joint design the arm will get you 0deg to +4deg of caster and +-2deg of camber. Get your tire where you want it in the wheel well: Use adjustment in the control arm and on the OE lower cams to maximize alignment angles and move oversized tires forward in the wheel well to minimize or avoid fender trimming. Do you need replacement cams for the lower control arm? Check out SPC p/n 25430, which will replace corroded cam bolt assemblies. * On the adjustable ball joint SPC uses hex chromate free finish and offers a 700hr salt spray test for the best corrosion protection available. California Residents WARNING